Setting up the Cisco 186 / 188 ATA's for use with FaktorTel

---

Step 1

You may first want to reset your unit to factory default setting. To do this, pick up the phone handset attached to the Line 1 jack and press the illuminated red button.

Dial: 322873738#

then dial: * and hang up.

NOTE: this will completely reset the unit to factory default settings, erasing any values that may already exist!

---

Step 2

Now, again pick up the phone handset and press the red button, then

Dial: 21 #

and you will be told the IP address of your device (e.g. 192.168.0.100).

---

Step 3

Go to any browser equipped computer on your network and enter the address: http:///dev (where is replaced by the address that was given to you in STEP 2.

---

Step 4

You need to modify only a few parameters from the factory default. They are listed here:

UID0: Enter the faktortel number you were given when you signed up. (Should start with 09)
PWD0: Enter the password that you were given when you signed up.
GkOrProxy: sip.faktortel.com.au
DisplayName0: Enter your full name. This will show up as part of your callerid.

---

Step 5

Click on the "apply" button on the bottom of the form.

---

Step 6

Congratulations! Your device should now be setup on the FaktorTel Network.

Once you are confident your device is setup try calling some of our free test service numbers located here