Setting Up Your LinkSys PAP2 With FaktorTel



The first thing you will need to do is to find out the address of your Linksys PAP2 device. Assuming you have plugged your LinkSys PAP2 in this is quite easy to do.

1. Simply Pick up the handset that is attached to your Linksys and dial **** 110#.

A voice will come onto the handset and start reading you numbers which sounds something like "192.168.0.11". Write down this number (including the dots).

Open a web browser on your computer and type this into your browser as: http://192.168.0.11 replacing 192.168.0.11 with the number your wrote down.

You should now be in the configuration menu of your LinkSys PAP 2 device. Which looks similar to the picture below:



Now you are inside the menu on the far right you will see a link which says "Admin Login" Click this link and you should see a menu like this appear:



You will now need to click on the link which says "Switch To Advanced View".

Your menu should now have grown significantly. Don't worry to much about this we're simply making it possible for us to access the settings we require.

At the top of the menu, click on the word "SIP". You should see a new menu appear.

Scroll right to the bottom of this menu and you should see two settings please set them as below:

  • Set Stun enable to Yes
  • Set Stun server to stun1.faktortel.com.au


Now scroll to the top of the page again and click on the "Regional Settings" words.

In this menu, set the following settings to the same as below:

  • Set interdigit long timer to 5
  • Set interdigit short timer to 1
  • Set FXS port impedance to 220+820|| 120NF


Now scroll back to the top again and click on the "Line 1" words (at the very top of the screen).

Set the following settings in this menu to match below:
  • Set Nat keep alive enable to Yes
  • Set Proxy to sip.faktortel.com.au
  • Set register expires to 120
  • Set Display Name to your name (E.g. Bob Smith)
  • Set User ID to the User ID provided to your by FaktorTel (E.g. 09123456)
  • Set Password to the password provided to you by FaktorTel


Now scroll down to the very bottom of the page and Click Save Settings and wait for device to Reboot

Your device should now be connected to FaktorTel.

For a list of test numbers click here