Setting up the SIPURA 2000 for use with FaktorTel.

Step 1

You must first determine what IP address it received. To do this, you need to pick up the phone attached to the Line 1 jack and dial: **** (four asterisks) then dial: 110 # and you will be told the IP address of your device (e.g. 192.168.0.100).

Step 2

Go to any browser equipped computer on your network and enter the address: http:/// (where is replaced by the address that was given to you in STEP 1.

Step 3

Click on the "Admin Login" button near the top right side of the screen, then click on the "Line 1" tab.



Step 4

You need to modify only a few parameters from the factory default. They are listed here:

Proxy: sip.faktortel.com.au
Display Name: Enter your Full name, this will show up as part of your callerid.
User ID: Enter the faktortel number you were given when you signed up. (Should start with 09)
Password: Enter the password that you were given when you signed up.


Step 5

Click on the "Submit All Changes" button at the bottom of the form.



Step 6

Change the “Preferred Codec” to G729a. Also change the “Use Pref Codec Only” to Yes. You can do this for both Line 1 and Line 2 (i.e. if you are going to use Line 2).

Step 7

Congratulations! Your device should now be setup on the FaktorTel Network.

Once you are confident your device is setup try calling some of our free test service numbers located here