Step 1:

You may first want to reset your unit to factory default setting. To do this, pick up the phone handset attached to the Line 1 jack and press the illuminated red button.

Dial: 322873738 #

then dial: * and hang up

Please Note: this will completely reset the unit to factory default settings, erasing any values that may already exist!

Step 2:

Now, again pick up the phone handset and press the red button, then

Dial: 21 #

and you will be told the IP address of your device ( e.g. 192.168.0.100 )

Step 3:

Go to any browser equipped computer on your network and enter the address: http:///dev (where is replaced by the address that was given to you in STEP 2.

Step 4:

You need to modify only a few parameters from the factory default. They are listed here:

UID0: Your FaktorTel USER ID

PWD0: Your FaktorTel PASSWORD

GkOrProxy: sip.faktortel.com.au

DisplayName0: Enter your full name. This will show up as part of your callerid.

Step 5:

Click on the "apply" button on the bottom of the form.

Congratulations! Your device should now be setup on the FaktorTel Network.